96acc5c1

11.10.1.3. Assembly


Power shafts on models with engines 5S-FE
 
1 – antidust cap;
2 – blooming ring;
3 – bearing;
4 – intermediate shaft;
5 – collars of fastening of protective covers;
6 – trekhplechy hinge;
7 – protective cover;
8 – protective cover;
9 – lock ring;
10 – collars of fastening of protective covers;
11 – power shaft;
12 – draft of the stabilizer of cross stability;
13 – lock-nut;
14 – forelock;
15 – tip of steering draft;
16 – left power shaft;
17 – lock ring;
18 – lock ring;
19 – bolt of fastening of the intermediate bearing;
20 – right power shaft;
21 – protection of a forward wing

Measurement of length of a power shaft on models with engines 5S-FE

PERFORMANCE ORDER
1. Wrap up a shlitsevy part of a power shaft an adhesive tape and establish protective covers of hinges of equal angular speeds on a power shaft.
2. Remove an adhesive tape from shlits of a power shaft and install the three-humeral hinge on a power shaft and fix it by a lock ring.
3. Fill with lubricant the case of the hinge of equal angular speeds and grease the three-humeral hinge.
4. Install the three-humeral hinge with a power shaft in the hinge case.
5. Establish a new protective cover on a power shaft so that the flange of a protective cover was established in flutes of a power shaft.
6. Moving the three-humeral hinge in the hinge case, establish the required length of a power shaft (see rice. Measurement of length of a power shaft on models with engines 5S-FE).
7. Using the screw-driver, let out the air from under a protective cover.
8. Fix a cover by a collar.