14.4.4. Filling and painting of a body

When performing spackling works it is necessary to have the wide flexible plastic or nylon pallet for giving of a surface of hard putty of smoothness. You make alignment of hard putty on the damaged site of a body so that to give it the required form and smoothness. As soon as it was succeeded to achieve approximately required contour, stop those smoothing down hard putty the pallet since at too long smoothing down it will begin to harden, stick on the pallet and to roll down therefore the surface will be damaged. Drawing the subsequent, thinner layer of hard putty should be made after drying of the previous layer and so until the level of hard putty does not begin to act slightly over the level of the processed site. After hard putty hardening its surplus needs to be removed with a metal scraper or a file. You make further processing, using a set of an emery paper. Begin processing with use of a coarse-grained emery paper and in the subsequent you pass to fine-grained. An emery paper have on wooden flat whetstone, otherwise it is impossible to achieve a plain surface. On a closing stage of grinding the waterproof emery paper should be moistened with water periodically. It gives processing mine of the puttied surface special smoothness. The puttied dent has to be surrounded on perimeter with a layer of pure metal. For removal from the processed site of dust and fats wash out the processed site water and wipe with the degreasing solution. Raise dust on the site a thin layer of light soil. It will help to reveal all defects allowed when processing in hard putty. The found defects level by means of a new layer of hard putty and again to a zashkurta a surface. Continue this procedure before receiving an ideal surface.

After that the field of repair is ready to final painting. Aerosol putting paint has to be carried out in the warm, dry, windless and easy atmosphere. When carrying out painting indoors it is necessary to moisten half of the working platform with water for prevention of hit in dust air. When coloring only of one panel, other parts of a body have to be covered from hit of paint on them with the newspaper attached by an adhesive tape. Before putting primer shake up capacity with it, apply primer on a trial surface and achieve that she laid down evenly. Put a thick layer of primer by drawing several thin layers. Polish the grounded surface a waterproof emery paper. At the same time do not forget to vat sbryzg the ground area water and to periodically moisten an emery paper in water. Before further coloring dry up the processed site. Drawing a paint coat is made by a spray. Thickness of a paint coat is reached by drawing several thin layers. Coloring needs to be begun from the center of the painted area and to move to edges back and forth motions until all painted surface, and also about 20 mm around it are not painted. Remove a protective film and newspapers 10–15 minutes later after drawing the last paint coat. Give the chance to fresh paint to harden within at least 2 weeks, then by means of an obnovitel of paint or thin abrasive polishing paste even the edges of the painted area to the level of old paint. Polish a surface.