96acc5c1

15:25. Safety airbag

General information


Prevention

When performing any works on the car equipped with a safety cushion during the moving and storage of a safety cushion it is necessary to observe the following precautions:

– not to disconnect the accumulator at the working engine;
– when performing any works on a security system or carrying out electric welding on the car deactivate a security system;
– if the lamp of the alarm system of a security system burns, it is necessary to address immediately on service station;
– it is necessary to transport the safety airbag separately a bag up;
– when transporting not to place a hand on a safety cushion;
– not to throw a safety cushion;
– not to sort a safety cushion;
– to exclude hit on a safety cushion of solvents or the clearing substances;
– not to subject a safety cushion to influence of temperature over 90 °C;
– not to allow contact of a safety cushion with an open flame;
– not to install on the car a safety cushion with defects or damages.


The safety airbag from the driver is installed as the standard equipment on all models. The safety cushion is established in the center of a steering wheel. The security system joins at inclusion of ignition and becomes more active the delay sensor which is switched on in the electronic control device. At malfunction of a security system on a combination of devices the bulb lights up.