| 1. Remove the transmission and a flywheel. |
|
2. The easiest way of extraction old uplotnitelno го rings is in that the screw-driver to hook on a sealing ring and to take it from a nest. |
| 3. Also sealing ring can be taken from a nest if to drill two small openings located in the opposite ends of a sealing ring in a ring. Screw in two self-cutting screws in the drilled openings of a sealing ring and, using flat-nose pliers, extend a sealing ring for heads of screws. |
| 4. The most reliable method of replacement of a back sealing ring of a bent shaft is that it is necessary to remove the oil pallet and a back cover of a bent shaft together with a sealing ring. |
|
5. Establish a back cover of a bent shaft together with condense with a telny ring on wooden whetstones and, using the hammer and the screw-driver, beat out an old sealing ring from a cover. |
|
6. Using wooden whetstone and the hammer, establish a new sealing ring of a bent shaft in a back cover. |
| 7. Clear the interfaced surfaces of the block of cylinders and a back cover of a bent shaft and install new laying on the block of cylinders. |
| 8. Being careful, establish a back cover with condense with a telny ring on the engine. |
| 9. Fix a back cover of a bent shaft by bolts, having tightened them the required moment, at the same time the lower edge of a back cover has to be flush with bottom edge of the block of cylinders of the engine. |
|
10. Further installation is made in the sequence, the return to removal. |
