| 1. If single pulleys were removed, establish them and a spring of stretching. Stretching a spring, move the top single pulley to the left as far as possible and temporarily fix by a bolt. |
| 2. Check tags of combination of a pulley of a distributive and bent shaft. |
| 3. Consistently establish a gear belt on pulleys of a bent shaft, the oil pump, water pump and single pulleys. If the belt is established repeatedly, combine those earlier made tags on a gear belt and pulleys. |
| |
4. Establish a guide of a gear belt to a pulley of a bent shaft. At the same time the convex party of a guide has to be directed to a pulley of a bent shaft. |
| 5. Establish the lower casing of a gear belt and a pulley of a bent shaft. |
|
6. Establish a gear belt on a camshaft pulley, at the same time constantly you hold tense a forward branch of a gear belt. |
| 7. Weaken a bolt of fastening of the top single pulley. At the same time the spring will turn a single pulley and will make a tension of a gear belt. |
| 8. If a spring of a tension of a gear belt silver, slowly turn a bent shaft clockwise on two whole revolutions and tighten a bolt of fastening of the top single pulley. If a spring of a tension of a gear belt green, turn a bent shaft on 1 7/8 turns and tighten a bolt of fastening of the top single pulley of a gear belt. |
|
9. Repeatedly check combination of adjusting tags. |
|
10. Further installation is made in the sequence, the return to removal. |
