96acc5c1

3.4.1. Engine 3VZ-FE


Arrangement of high-voltage wires on an ignition distributor cover

PERFORMANCE ORDER
1. Note position of the plug of the first cylinder on a distributor cover. If the tag is absent, determine it by the high-voltage wire going from a candle of the first cylinder.
2. Using chalk or a felt-tip pen, put the tag located under contact of the first cylinder on the distributor case.
3. Uncover the distributor and move it aside.
4. Turn a bent shaft of the engine until the tag on a pulley of a bent shaft is combined with figure 0 on a plate of the installation of the mechanism of gas distribution located on the forward party of the engine.
5. Check the provision of a rotor of the distributor which has to be directed to the tag applied on the distributor case. If the rotor of the distributor is sent to the opposite side, then the piston of the first cylinder is in the top dead point in an exhaust step.
6. For installation of the piston of the first cylinder in VMT in a step of compression turn a bent shaft on 360 ° clockwise. At the same time the rotor of the distributor has to be combined with a tag.