| |
1. Using a special tester for check of system of ignition without distributor, connect a tester clip to the weight and a high-voltage wire and turning the engine a starter, watch a tester electrode to define existence of a spark. |
| 2. If the spark is present, so on a spark plug tension moves. Similarly check presence of a spark on other cylinders. |
|
|
3. If the spark is absent or its admissions are observed, check tension on the ignition coil. |
| 4. If the spark still is absent, check sensors the provision of distributive and cranked shaft. |
|
|
5. If the spark still is absent, check receipt of a signal from the ignition block for coils. Remove sockets from each coil and connect a LED sampler. Turning the engine a starter, watch a sampler which has to blink that demonstrates receipt of signals from the ignition block to the coil. |
| 6. If the spark still is absent, replace the ignition block. |
