96acc5c1

7.7. Check and adjustment of a corner of an advancing of ignition


Tools necessary for check and adjustment of a corner of an advancing of ignition

1 – vacuum traffic jams which need to be used for closing of the vacuum hoses disconnected during check of a corner of an advancing of ignition;
2 – stroboscope;
3 – wrench necessary for weakening of a bolt of fastening of the distributor of ignition


PERFORMANCE ORDER
1. Connect a tachometer according to the instruction of manufacturer. 2. Using an additional wire, connect contacts of E1 and TE1 of the control socket.
3. Connect a stroboscope according to the instruction of manufacturer. Establish a measuring wire of a stroboscope on a high-voltage wire of the first cylinder.
4. Combine adjusting tags on a casing of a gear belt and a pulley of a bent shaft. 5. Start the engine, warm up it up to the normal working temperature and measure idling turns. Direct stroboscope light to the index with a scale of an advancing of ignition and a pulley of a bent shaft. At the same time the tag on a pulley has to be combined with S tag on an index scale. If it is necessary, weaken a bolt of fastening of the distributor of ignition and slowly turn the ignition distributor until the tag on a pulley of a bent shaft is not combined with S tag on the index.
6. Remove the additional closing wire with a diagnosticha of the sky socket and check that the corner of an advancing of ignition moved from 12 to 22 degrees forward.
7. Switch off the engine and remove a tachometer and a stroboscope.